Alvarion BreezeACCESS Wi2 System Manual page 51

A 50 cm pole (diameter 6.03 cm)
Screws for attaching the pole to mounting bracket
To mount the tilt accessory on a wall:
1
Place the bracket on the wall and use as a template to mark the position of the holes to be drilled
for the screws .
2
Remove the bracket from the wall and drill a hole in each of the locations marked.
3
Insert anchors into the holes.
4
Hold the bracket over the holes and insert a screw into each of the holes in the bracket, and
screw into the anchors in the wall. Secure the bracket to the wall, making sure that the screw
heads are as level with the bracket as possible.
To mount the tilt accessory on a non-vertical pole:
Thread the metal bands provides with the tilt accessory through the slits in the bracket and
attach to the pole as shown in
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 2-13: Tilt Accessory Kit
Figure 2-14.
Installation
29