Alvarion BreezeACCESS Wi2 System Manual page 47

2.3.3.3 Connecting to BreezeACCESS ODU with HW Revision E
1
Adapt the cable as described in
2
Connect the cable to the ODU as described in
2.3.3.4 Connecting to BreezeACCESS ODU with HW Revision D or
Lower
1
Cut the cable as close as possible to the connector that should be connected to the ODU (the end
without the service box).
2
Route the cable through the service box supplied with the SU-ODU.
3
Connect the spare RJ-45 connector, supplied with the cable kit, as described in step 2 of
Section 2.3.3.2
4
Connect the Ethernet cable to the SU-ODU RJ-45 connector.
5
Make sure that the external jacket of the cable is well inside the service box to guarantee a good
seal.
6 Verify that the O-ring of the service box kit is in place, attach the service box to the unit and
tighten the top nut.
7 Connect the other end of the cable to the SU port on the Wi² unit.
8 Make sure that the external jacket of the cable is well inside the service box to guarantee a good
seal. Verify that the O-ring supplied with the service box is in place, attach the service box to the
unit and tighten the top nut.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Wire color
Blue/white
Orange
Orange/white
Brown
Brown/white
Green
Green/white
Section 2.3.3.2
Pin
2
3
6
4
5
7
8
Section 2.3.3.1.
Installation
25