Wireless Security Filters - Alvarion BreezeACCESS Wi2 System Manual

the customer's RADIUS account (if using RADIUS-based authentication). Also, a global VLAN
setting is available on the Network > Ports page which will tag all traffic sent on port 1 and 2.
In the above example, with all defaults selected, the MAP bridges all wireless traffic to the wired
LAN.
5.3.3

Wireless Security Filters

APs feature an intelligent bridge that can apply security filters to safeguard the flow of wireless
traffic. These filters limit both incoming and outgoing traffic as defined below and force the APs to
exchange traffic with a specific upstream device.
If Use Alvarion access controller is enabled (under General), the AP will only forward user
traffic that is addressed to the service controller. All other traffic is blocked. Make sure that the
service controller is set as the default gateway. If not, all user traffic will be blocked by the AP.
If Use Alvarion access controller is disabled (under General), then the security filters can be
used to block traffic unless it is addressed to a specific device.
Figure 5-14: Security Filters When 'Use Alvarion Access Controller' is disabled
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 5-12: Egress VLAN
Figure 5-13: Wireless Security Filters
Virtual Network Configuration Options
81