Table of Contents
Advertisement
4
Strip insulation from wires as shown in
5
Insert bare wire ends into the terminals and fully tighten the screws. The wires should be
connected as shown below:
Brown
Blue
Yellow/green
6
Draw cable back until socket insert is correctly seated in D-shaped location in the main body.
Tighten the Gland nut. Screw back the locking ring using the cap assembly tool.
7
For an AC cable, connect a mains plug to the other end of the cable. For a DC cable, connect the
appropriate termination.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 2-11: Preparing the Power Cable
Figure
AC
Phase ~
Neutral 0
Grounding
2-11.
DC
Red
+
Black
-
Installation
27
Advertisement
Table of Contents
