Table of Contents
Advertisement
Gateway: IP address of the gateway to which the AP forwards routed traffic (known as the next
hop).
An asterisk is used by system routes to indicate a directly connected network.
Metric: Priority of a route. If two routes exist for a destination address, the AP chooses the one
with the lower metric.
7.6.1.2
Default Routes
The Default routes table shows all default routes on the AP. Default routes are used when traffic
does not match any route in the Active routes table. You can add routes by specifying the
appropriate parameters and then selecting Add.
The routing table is dynamic and is updated as needed. If more than one default route exists, the first
route in the table is used.
The following information is shown for each default route:
Interface: The port through which traffic is routed. When you add a route, the AP automatically
determines the interface to be used based on the Gateway address.
Gateway: IP address of the gateway to which the AP forwards routed traffic (known as the next
hop).
An asterisk is used by system routes to indicate a directly connected network.
Metric: Priority of a route. If two routes exist for a destination address, the AP chooses the one
with the lower metric.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
IP Routes
127
Advertisement
Table of Contents
