Table of Contents
Advertisement
10.7
How to Configure Local Mesh in Controlled Mode
The configuration of local mesh in controlled mode comprises the following steps:
Setting a Master Profile
Setting the Master AP
Setting the SLAVE AP
Adding the Slave AP in a Group on the Controller
10.7.1
Setting a Master Profile
To set a Master Profile:
Using a factory reset controller do the following:
1
Creat a new Group within the controller by clicking on "Controlled APs > Group
Management > Add a new group"
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 10-8: Group Management
How to Configure Local Mesh in Controlled Mode
187
Advertisement
Table of Contents
