Alvarion BreezeACCESS Wi2 System Manual page 37

Status Light
Power Act
Link on Ethernet
Link on Wireless
Power
2.1.3.2 Controlled Mode
The status lights provide the following information when an AP is operating in controlled mode:
Status Light Behavior
Power Act blinks slowly.
Power Act, Link on Ethernet, and Link on Wireless
light each turn ON and OFF one after the other,
giving the impression of movement from left to right
Power Act light is solid.
Link on Ethernet blinks until the tunnel is established.
Power Act light and Link on Ethernet light blink
alternatively and quickly.
Wireless light is off.
Once the AP has established a secure tunnel with a CTRL, the status lights revert to their normal
operation:
Power light is solid to indicate that the AP is fully operational
Ethernet light blinks to indicate the presence of traffic on the Ethernet port
Wireless light blinks to indicate the presence of traffic on the wireless port
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
State Description
Off There is no power to the WI2SR-1.
Flashing The WI2-SR-1 is starting up.
Solid The WI2-SR-1 is fully operational.
Off Port is not connected or there is no activity.
Flashing Ethernet port is transmitting or receiving.
Solid The light comes on for a short period when the link is established.
Flashing Wireless port is receiving data.
Solid When the WI2-SR-1is plugged in.
Description
WI2-SR-1 is looking for an IP address
WI2-SR-1 has obtained an IP address and is
attempting to discover a WI2-SR-CTRL.
WI2-SR-1 has found a WI2-SR-CTRL and is
attempting to establish a secure tunnel with it.
WI2-SR-1 has received a discovery reply from two or
more WI2-SR-CTRLs with the same priority setting.
The WI2-SR-1 is unable to connect with either until
the priority conflict is resolved.
Hardware Description
15