Table of Contents
Advertisement
Chapter 7 - Network Configuration
7.3
Bandwidth Control
The AP incorporates a bandwidth management feature that provides control of outgoing user traffic
on the wireless ports.
To configure Bandwidth control, select Network > Bandwidth control.
If outgoing traffic arrives at the defined bandwidth limit (or less), it is processed without delay.
If outgoing traffic arrives at a rate that is greater than the defined bandwidth limit, it causes the
AP to throttle the traffic. If the traffic rate is over-limit for just a short burst, the data will be
queued and forwarded without loss. If the traffic rate is over-limit for a sustained period, the AP
will drop data to bring the rate down to the bandwidth limit that is set.
For example, if you set bandwidth control to 5000 kbps, the maximum traffic that can be sent to
client stations on each wireless port is 5000 kbps.
122
Figure 7-6: Bandwidth Control
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Advertisement
Table of Contents
