Table of Contents
Advertisement
Chapter 10 - Local Mesh
5
When this AP is back UP, place it on the same subnet as your controller
6
The AP should now discover the controller and synchs UP in the controller's DEFAULT
GROUP
7
Drag and drop this AP from the DEFAULT GROUP into the created group in
step1
8
The AP should now synch into the created group restoring all the configuration done in STEPS
(2 - 5)
9
Now you will have an active VSC bounded to the MASTER
10.7.3
Setting the SLAVE AP
1
Power UP another AP in Autonomous mode (Alvarion Default Mode)
2
Login to the AP's web tool
3
Click on "Maintenance > System"
4
Click on the "Provisioning" button at the bottom on this page to start provisioning the SLAVE
AP
192
Figure 10-13: Switch to Controlled Mode
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Section 10.7.1
Advertisement
Table of Contents
