Alvarion BreezeACCESS Wi2 System Manual page 159

If login to the management tool fails five times in a row (bad username and/or password), login
privileges are blocked for five minutes. Once five minutes expires, login privileges are once
again enabled. However, if the next login attempt fails, privileges are again suspended for five
minutes. This cycle continues until a valid login occurs. This option is not configurable.
8.1.3.4 Web Server
You can also configure the web server ports from which access to the management tool is permitted.
Secure web server port: Specify a port number for the AP to use to provide secure HTTPS
access to the management tool. Default is 443.
Web server port: Specify a port number for the AP to use to provide standard HTTP access to
the management tool. These connections are met with a warning, and the browser is redirected
to the secure web server port. Default is 80.
8.1.3.5 Security
The management tool is protected by the following security features:
HTTPS: Communications between a management station and the AP is protected using the
Secure Hypertext Transport Protocol. Before logging on to the management tool, you must
accept a security certificate. A default certificate is provided with the service controller. You can
replace this certificate with your own. For more information, see
page
Port blocking: You can enable or disable access to the management tool for each of the
following:
LAN port
Internet port
VPN
VLAN/GRE/Mesh
Allowed IP address: You can configure a list of subnets from which access to the management
tool is permitted.
NOTE
These security settings also apply when SSH is used to access the command line interface.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
161.
Management Tool
"Managing Certificates" on
137