Table of Contents
Advertisement
Chapter 3 - Hardware Installation Wi² Extender
3.2.2
Additional/Optional Installation Requirements
Category 5E cable* for connecting to a Wi² Extender if installed separately (maximum length
100m.)
Rubber sealing cap for BreezeMAX or BreezeACCESS HW Revision E ODU (supplied with
Wi² Extender)
Service Box for BreezeACCESS HW Revision D or lower ODU (supplied with Wi² Extender).
Crimping tool for RJ-45 connectors (if connecting to a BreezeACCESS ODU)
RS232 console cable*
8 dBi Omnidirectional antenna(s)*
Sectoral antenna(s), including RF cable with N-Type connector*
UL/CSA listed smooth circular power cable, 1.5mm to 2.5mm each. Outer diameter 7mm to
9mm, UV resistant, temperatures range -40
resistance, no of wires) according to specific installation requirements.
A mains plug for connecting to AC mains
Two terminal rings if connecting to a DC source
Grounding cable with an appropriate termination.
Installation tools and materials, including appropriate means for installing the Wi² Extender and
antenna(s).
A PC with an Ethernet NIC for configuring basic parameters of the WiFi AP and the SU-ODU,
and a b/g WiFi card for testing wireless connectivity to the AP.
Wall - Tilt Pole Mounting kit*
DC power connector* (pack of 5)
Waterproof covers for AC/DC socket* (pack of 5)
40
0
0
C to +65
C min. Other specifications (such as oil
(page
28)
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Advertisement
Table of Contents
