Bridge Port Configuration - Alvarion BreezeACCESS Wi2 System Manual

7.1.2

Bridge Port Configuration

All ports on the AP are bridged. Therefore, common settings are configured using the bridge port
(which is a logical port). To verify and possibly adjust bridge port configuration, select Network >
Ports > Bridge port.
7.1.2.1 Assigning an IP Address
The bridge port supports the following addressing options:
PPPoE client
DHCP client (default setting)
Static
By default, the bridge port operates as a DHCP client. Select the addressing option that is required
by your network administrator and then select Configure. Refer to the online help for descriptions
of all configuration options.
7.1.2.2 Bridge Spanning Tree Protocol
When this option is enabled, the AP uses the Spanning-Tree Protocol to prevent undesirable loops
from occurring in the network that may result in decreased throughput.
Spanning tree can be enabled for untagged ports and/or VLAN ports.
When VLAN support is enabled, it applies to VLANs defined on the Network > Ports page only. It
does not apply to the management VLAN defined in the VLAN box on the Network > Ports >
Port 1 or Port 2 page.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 7-2: Bridge Configuration
Port Configuration
115