Attaching The Mounting Plate To The Wi² Unit - Alvarion BreezeACCESS Wi2 System Manual

Figure 2-6: Attaching BreezeACCESS SU-ODU with HW Revision D or lower to Mounting Plate
NOTE
Sometimes, physical circumstance require that the SU-ODU be located at a distance from the Wi²
unit and not attached to the mounting plate. For further information see the section on SU-ODU
mounting in the relevant manual.
2.3.2 Attaching the Mounting Plate to the Wi² Unit
1
Hold the mounting plate with SU-ODU attached so the tilt label faces the tilt direction that you
have decided upon (see
2
Using the M6 x 12 hex head screws and the flat washers and spring washers supplied, attach the
mounting plate to the Wi² unit as shown in
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Section 2.3.1).
Figure 2-7.
Installation
21