Table of Contents
Advertisement
Chapter 2 - Hardware Installation
2.2
Installation Requirements
This section describes all the supplies required to install the Wi² and the items included in each
installation package.
2.2.1
Packing List
The BreezeMAX Wi² and BreezeACCESS Wi² installation kit includes the following components:
Wi² unit
SU-ODU mounting plate
4 sets of M8 x 16 hex head screws + flat washers + spring washers
4 sets of 1/4" x 1/2" hex head screws + flat washers + spring washers
4 sets of M6 x 12 hex head screws + flat washers + spring washers
Cable kit including a 55 cm category 5E Ethernet cable with two shielded RJ-45 connectors, one
with a metal service box, and a spare shielded RJ-45 connector.
AC power connector
2 x 9/16" (530 mm) metal bands
3m Ethernet configuration cable (2 pairs, straight)
2.2.2
Additional/Optional Installation Requirements
Category 5E cable* for connecting to an SU-ODU if installed separately (maximum length
100m.)
Rubber sealing cap for BreezeMAX or BreezeACCESS HW Revision E ODU (supplied with
SU-ODU)
Service Box for BreezeACCESS HW Revision D or lower ODU (supplied with SU-ODU).
Crimping tool for RJ-45 connectors (if connecting to a BreezeACCESS ODU)
RS232 console cable*
16
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Advertisement
Table of Contents
