Alvarion BreezeACCESS Wi2 System Manual page 162

Chapter 8 - Management
8.2.1.1 Attributes
System name: Specify a name to identify the AP. Default is the AP's serial number.
Location: Specify a descriptive name for the location where the AP is installed.
Contact: Specify information about a contact person for the AP.
Community name: Specify the password that controls read/write access to SNMP information.
A network management program must supply this password when attempting to set or get
SNMP information from the AP. By default, this is set to private.
Confirm community name: Reenter the Community name.
Read-only name: Specify the password that controls read-only access to the SNMP
information. A network management program must supply this password when attempting to
get SNMP information from the AP. By default the Read-only name is public.
Confirm read-only name: Reenter the Read-only name.
8.2.1.2 Agent
The SNMP agent is active by default. If you disable the agent the AP will not respond to SNMP
requests.
Port: UDP port and protocol the AP uses to respond to SNMP requests. Default port is 161.
SNMP Protocol: SNMP version supported. Default is Version 2c which also supports requests
from agents using version 1.
8.2.1.3 Security
Use these settings to control access to the SNMP interface.
Allowed addresses: List of IP address from which access to the SNMP interface is permitted.
To add an entry, specify the IP address and appropriate Mask, and then select Add.
When the list is empty, access is permitted from any IP address.
Active interfaces: Enable the checkboxes that correspond to the interfaces from which to allow
access to the SNMP interface.
140 BreezeMAX Wi² and BreezeACCESS Wi² System Manual