Table of Contents
Advertisement
CAUTION
The Wi² Extender can be connected to either an AC or DC power source, or to both. By default the
DC plug is covered with a waterproof sealing cap which must be removed before connecting to the
power cable. Any socket that is NOT in use must always be protected from moisture and must be
covered with a waterproof sealing cap.
2
Check that the LED on the Wi² Extender is green indicating that the system is working
normally.
3.7.4
Configuration and Testing
3.7.4.1
Configuring the SU-ODU
1
Disconnect the cable connecting the WiFi Access Point (AP) from the AP connector on the
Power Supply and Interface module.
2
Connect a PC to the AP connector using the 3 m configuration cable (straight) supplied with the
unit.
3
Verify that the SU-ODU is connected to the SU connector on the Power Supply and Interface
module.
4
Using Telnet, connect to the SU-ODU and configure its parameters. For configuration details
refer to the relevant manual.
5
Verify that the SU-ODU is operating properly and that it connects to the base station. For details
on verifying proper operation and connectivity refer to the relevant manual.
3.7.4.2
Configuring the Wi² Extender
1
Disconnect the configuration cable from the unit and reconnect the cable between the WiFi
Access Point (AP) and the AP connector of the Power Supply and Interface module.
2
Disconnect the cable connected to the SU connector on the Power Supply and Interface module.
3
Connect a PC to the SU connector using the 3 m configuration cable.
NOTE
Alternatively, instead of disconnecting the SU connector, you can connect a PC to the Console port
of the AP with a console cable (ordered separately) and complete all the configuration using CLI.
4
Using Telnet, log in, and set the country code (available only via CLI) and the AP IP address as
outlined in
5
Complete the configuration of the AP, using either CLI as outlined in the AP CLI Reference
Guide or the web-based interface as outlined in
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Chapter 4 - "Getting
Started".
Chapter
8.
Align the Antenna
57
Advertisement
Table of Contents
