Table of Contents
Advertisement
Chapter 3 - Hardware Installation Wi² Extender
Ethernet cable
to Wi² Extender
3
Insert the power cable plug directly into the standard AC receptacle on the power injector.
4
Plug the other end of the power cable into a grounded, 3-pin socket, AC power source.
NOTE
For International use, you may need to change the AC line cord. You must use a line cord set that
has been approved for the receptacle type in your country.
5
Check the Power LED on top of the power injector IDU to be sure that power is being supplied
to it.
52
RADIO
RESET
E T
E R N
E T H
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
AC power
Ethernet cable
from LAN switch
Advertisement
Table of Contents
