Table of Contents
Advertisement
Chapter 9 - Security
9.2.5.4
Changing the Certificate Assigned to a Service
Select the service name to open the Certificate details page. For example, if you select Web
management tool, you will see:
Figure 9-5: Changing the Certificate Assigned to a Service
Under Authentication to the peer, select a new Local certificate and then select Save.
9.2.6
About Certificate Warnings
Access to the management tool must occur through a secure connection (SSL). Until a certificate is
installed, certificate warnings will appear at login.
To continue to work with the management tool without installing a certificate, proceed as follows:
At the security certificate prompt, in Microsoft Internet Explorer 7, select Continue to this website;
in Firefox 2, select Accept this certificate temporarily for this session and OK.
To eliminate these warnings you can purchase a valid SSL certificate (from a source such as
Verisign) that will work with the default configuration of your web browser, and install it on the
service controller.
The following is an example of a security warning displayed by Internet Explorer 7:
166
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Advertisement
Table of Contents
