Appendix B - Resetting to Factory Defaults
B.1.3
Using Special Commands
NOTE
Follow the directions in this section only for the outdoor ruggedized Wi² AP units AND ONLY when
you do not have access to the unit via its management tool.
NOTE
This option is only available on units with serial numbers beginning with B027 or higher, purchased
after March 1, 2006.
NOTE
This technique forces the AP into its factory default state including switching the AP back into
controlled mode.
In addition to the AP, you need the following items:
The file Wi2Remote.bat available for download from the Alvarion extranet at
https://extranet.alvarion.com.
A crossover Ethernet cable
A standard (not crossover) Ethernet cable
A PoE injector
222
Figure B-2: System
BreezeMAX Wi² and BreezeACCESS Wi² System Manual