Table of Contents
Advertisement
Chapter 2 - Hardware Installation
Figure 2-5: Attaching BreezeMAX PRO-S ODU or BreezeACCESSSU-ODU with HW Revision E to
NOTE
For information about polarization refer to the relevant manual.
To attach a BreezeACCESS SU-ODU with HW Revision D or lower (rectangular) to
the mounting plate:
1
Determine the tilt direction of the SU-ODU.
2
Using the 1/4" x 1/2" hex head screws and the flat washers and spring washers supplied, attach
the SU-ODU to the mounting plate as shown in
3
Tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
20
Mounting Plate
Figure 2-6
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
in the direction marked.
Advertisement
Table of Contents
