Table of Contents
Advertisement
2.3
Installation
The following sections describe how to install a Wi² unit, including attaching the SU-ODU to the
mounting plate, attaching the mounting plate to the Wi² unit, connecting to the SU-ODU, pole
mounting, connecting a grounding cable, and connecting the antenna(s).
2.3.1
Attaching the SU-ODU to the Mounting Plate
IMPORTANT
The angle at which the SU-ODU is mounted on the Wi² can be adapted depending on the location
of the Wi² unit in relation to the Base Station. Once attached, the mounting plate can be tilted either
up or down. Before attaching the SU-ODU to the mounting plate, determine the direction of the tilt
To attach a BreezeMAX PRO-S ODU or BreezeACCESSSU-ODU with HW Revision E
(octagonal) to the mounting plate:
NOTE
BreezeACCESS SU-ODU with HW Revision E is the new, smaller, octagonal ODU available in the
5.4 and 5.8 GHz bands. BreezeACCESS SU-ODUs with HW Revision D or lower are rectangular
and slightly larger in size.
1
Determine the tilt direction of the SU-ODU.
2
Using the M8 x 16 hex head screws and the flat washers and spring washers supplied, attach the
SU-ODU to the mounting plate as shown in
3
Tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 2-5
in the direction marked.
Installation
.
19
Advertisement
Table of Contents
