Table of Contents
Advertisement
The color codes used in the standard cable supplied by with the unit are listed in the table below.
3.7.0.2
Connecting to BreezeACCESS ODU with HW Revision E
1
Adapt the cable as described in
2
Connect the cable to the ODU as described in
3.7.0.3
Connecting to BreezeACCESS ODU with HW Revision D or
Lower
1
Cut the cable as close as possible to the connector that should be connected to the ODU (the end
without the service box).
2
Route the cable through the service box supplied with the SU-ODU.
3
Connect the spare RJ-45 connector, supplied with the cable kit, as described in step 2 of
Section 3.7.0.1
4
Connect the Ethernet cable to the SU-ODU RJ-45 connector.
5
Make sure that the external jacket of the cable is well inside the service box to guarantee a good
seal.
6
Verify that the O-ring of the service box kit is in place, attach the service box to the unit and
tighten the top nut.
7
Connect the other end of the cable to the SU port on the Wi² Extender unit.
8
Make sure that the external jacket of the cable is well inside the service box to guarantee a good
seal. Verify that the O-ring supplied with the service box is in place, attach the service box to the
unit and tighten the top nut.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Wire color
Blue
Blue/white
Orange
Orange/white
Brown
Brown/white
Green
Green/white
Section 3.7.0.1
Pin
1
2
3
6
4
5
7
8
Section
2.3.3.1.
Align the Antenna
55
Advertisement
Table of Contents
