Table of Contents
Advertisement
Chapter 2 - Base Station InstallationBase Station Connectors and LEDs
Chapter 2 - Base Station Installation
2.5
Base Station Connectors and LEDs
Figure 2-1: Base Station Connectors and LEDs (a unit with both omni and sector antennas)
IMPORTANT
The USB connector does not function as a standard USB port and is intended for special engineering
NOTE!
purposes only. Ensure that the USB connector and RST button are properly sealed with the plastic cap.
For details on using the RST (Reset) button refer to
page
112.
For details on the functionality of the Status LEDs refer to
2.6
Preparing and Connecting the Outdoors Ethernet
Cable
It is recommended to attach the Ethernet connector to the cable and connect it to the base station prior
to mounting the outdoor unit. Typically the connector on the other side will be attached only after
completing the outdoor installation and routing the open-ended cable to the location intended for the
PoE Injector.
For detailed instructions on how to prepare the Ethernet cable refer to
Ethernet Cable" on page
WBSn-2400 and WBSn-2450 System Manual
"Using the Reset Button of the Base Station" on
116.
Base Station Connectors and LEDs
"Base Station LEDs Description" on page
"Preparing the Base Station's
111.
12
Advertisement
Table of Contents
