Chapter 2 - Installation
Wall Mounting the Unit
Use the supplied brackets for wall mounting to install the unit on a wall
or a ceiling.
To mount the unit on a wall:
1. Turn the unit so the rear panel is facing you.
2. Unscrew the two screws located at the antennas end of the unit (the
top screws).
3. Align the Unit Mounting Slots (see Figure 2-11) with the slots you
have just unscrewed.
4. Using the longer screws supplied with the wall mounts, screw the
wall mount to the unit.
5. Align the Convenience Mounting Slots (see Figure 2-12) with the
nails, push the wall mount against the wall and let it slide down
until it rests on the nails.
Special slots have been added to the wall mounts to allow for
unobtrusive cable installation. These slots should be used to fasten
cables coming out of the unit to the wall mounts, eliminating loose or
tangled cable installations.
2-20
Figure 2-11: Wall Mounting the SU-I
Convenience Mounting Slots
Unit Mounting Slots
Cable Fastening Slots
Figure 2-12: Wall Mounting Plate
BreezeACCESS 900 System Manual rev 1.1