Chapter 2 - Hardware Installation
2.3.4
Grounding Point
Even though the SU-A-EZ includes its own built-in lightning protection, it is
important that the unit is properly connected to ground. A grounding screw is
provided for attaching a ground wire to the unit.
2.3.5
Water Tight Test Point
CAUTION
Do no remove or loosen this screw. Doing so could lead to damage of the unit.
2.3.6
Pole-Mounting Bracket Attachment Points
The SU-A-EZ includes a bracket kit that can be used to mount the unit to a pole,
radio mast, or part of a tower structure.
2.3.7
LED Indicators
The SU-A-EZ includes status LED indicators located on the base of the unit, as
indicated in the following figure.
The following table describes the system status LEDs:.
LED
Power
Link
14
802.11a Wireless
Signal Strength
11a
Status
Description
On Green
Indicates that the system is working normally.
On Amber
Indicates a system reset.
On Green
Indicates a valid 10/100 Mbps Ethernet cable link.
Flashing Green
Indicates that the SU-A-EZ is transmitting or receiving data
on a 10/100 Mbps Ethernet LAN. Flashing rate is
proportional to network activity.
Power
Power
Link
Ethernet
Link/Activity
Installation