A/C Compressor Drive Belt (If Equipped) Inspection; Valve Lash (Clearance); Engine Oil And Oil Filter - Suzuki Ignis Service Manual

0B-6 MAINTENANCE AND LUBRICATION
A/C COMPRESSOR DRIVE BELT (IF EQUIPPED) INSPEC-
TION
1) Disconnect negative (–) cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanli-
ness. If any defect exists, replace.
Check belt for tension.
If belt tension is out of specification, adjust it referring to
"COMPRESSOR DRIVE BELT" in Section 1B.
A/C compressor drive belt tension
"a" : 3 - 5 mm (0.12 - 0.20 in.) deflection under 100 N
(10 kg, 22 lb) pressure
3) Connect negative (–) cable to battery.
REPLACEMENT
Replace belt with new one referring to "COMPRESSOR DRIVE
BELT" in Section 1B.

VALVE LASH (CLEARANCE)

INSPECTION
1) Inspect intake and exhaust valve lash and adjust as neces-
sary.
Refer to "VALVE LASH" in Section 6A1 for valve lash
inspection and adjustment procedure.
1. Camshaft
2. Thickness gauge

ENGINE OIL AND OIL FILTER

REPLACEMENT
WARNING:
• New and used engine oil can be hazardous.
Be sure to read "WARNING" in General Precaution in
Section 0A and observe what in written there.
• Step 1) - 7) outlined below must be performed with
ENGINE NOT RUNNING. For step 8), be sure to have
adequate ventilation while engine is running.
Before draining engine oil, check engine for oil leakage. If any evi-
dence of leakage is found, make sure to correct defective part
before proceeding to the following work.