Dtc Check; Using Suzuki Scan Tool; Not Using Suzuki Scan Tool - Suzuki Ignis Service Manual

3B1-8 ELECTRICAL POWER STEERING (P/S) SYSTEM
3

DTC CHECK

USING SUZUKI SCAN TOOL

1
(C)
(A)
(B)

NOT USING SUZUKI SCAN TOOL

3
1
4
2
1) Turn ignition switch to OFF position.
2) After setting cartridge connect SUZUKI scan tool to data link
connector (DLC) (1) located on underside of instrument
panel at driver's seat side.
Special tool
(A) : 09931-76011
(B) : Master storage cartridge
(C) : 09931-76030
3) Turn ignition switch to ON position.
4) Read DTC according to instructions displayed on SUZUKI
scan tool and print it or write it down referring to SUZUKI
SCAN TOOL OPERATOR'S MANUAL for further details.
NOTE:
If Suzuki scan tool cannot display DTC, perform "SERIAL
DATA LINK CIRCUIT CHECK" described in this section.
5) After completing the check, turn ignition switch to OFF posi-
tion and disconnect SUZUKI scan tool from DLC.
1) Remove glove box.
2) Apply chocks to wheels, set shift lever to neutral position and
pull parking brake fully.
3) Start engine.
4) Using jumper wire (4), short diagnosis switch terminal (1) to
ground terminal (2) of monitor coupler (3).
5) Read flashing of "EPS" warning lamp which represents DTC
and write it down. When more than 2 DTCs are stored in
memory, each DTC is repeated 3 times starting with the
smallest DTC number in increasing order.
For details and example of DTC, refer to "DTC TABLE".
NOTE:
DTC No.22 is indicated when ignition switch is ON and
engine is not running but if DTC No.12 is indicated when
engine is started, it means nothing abnormal.
6) After completing the check, turn ignition switch to OFF posi-
tion and disconnect jumper wire (4) from monitor coupler.