Subaru Impreza 2003 Service Manual page 3287

CLEAR MEMORY MODE
IMMOBILIZER (DIAGNOSTICS)
7. Clear Memory Mode
A: OPERATION
1) On the «Main Menu» display screen, select the
{2. Each System Check}, and then press the [YES]
key.
2) On the «System Selection Menu» display
screen, select the {Engine Control System}, and
then press the [YES] key.
3) Press the [YES] key after the information of en-
gine type is displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {Clear Memory}, and then press the [YES]
key.
5) When the 'Done' are shown on the display
screen, turn the Subaru Select Monitor and ignition
switch to OFF.
NOTE:
• After the memory has been cleared, the ISC
must be initialized. To do this, turn the ignition
switch to ON position. Wait 3 seconds before start-
ing the engine.
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
IM-9