Subaru Impreza 2003 Service Manual page 3269

DIAGNOSTIC PROCEDURE WITH DTC
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
8. Diagnostic Procedure with DTC
A: DTC 21, 24, 25 AND 2A CRUISE CONTROL MODULE BUILT-IN RELAY, CPU
RAM
DIAGNOSIS:
• Poor welding of built-in relay of cruise control module.
• Failure of built-in CPU RAM of cruise control module.
TROUBLE SYMPTOM:
• Cruise control is canceled and memorized cruise speed is also canceled.
• Once cruise control is canceled, cruise control cannot be set until the ignition switch and cruise control
main switch turns OFF, and then turns ON again.
NOTE:
Check input/output signal and vehicle speed signal with select monitor. When signals are in good condition,
failure is in cruise control module. (Check the power supply and ground conditions of cruise control module.)
CC-25