Subaru Impreza 2003 Service Manual page 3253

SUBARU SELECT MONITOR
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
8) Drive the vehicle at least 40 km/h (25 MPH) with
cruise speed set.
9) If the cruise speed is canceled itself (without do-
ing any cancel operations), a DTC will appear on
select monitor display.
CAUTION:
• A DTC will also appear when cruise cancel is
effected by driver. Do not confuse.
• Have a co-worker ride in the vehicle to assist
in diagnosis during driving.
NOTE:
DTC will be cleared by turning the ignition switch or
cruise control main switch to OFF.
3. REAL-TIME DIAGNOSIS
1) Connect the select monitor.
2) Turn the ignition switch and cruise control main
switch to ON.
3) Turn the Subaru Select Monitor switch to ON.
4) On the Main Menu display screen, select the
{Each System Check} and press [YES] key.
5) On the System Selection Menu display screen,
select the {Cruise Control} and press [YES] key.
6) Press the [YES] key after displayed the informa-
tion of engine type.
7) On the Cruise Control Diagnosis display screen,
select the {Current Data Display & Save} and press
[YES] key.
8) Make sure that normal indication is displayed
when controls are operated as indicated below:
• Depress/release the brake pedal. (Stop light
switch and brake switch turn ON.)
• Turn ON the "SET/COAST" switch.
• Turn ON the "RESUME/ACCEL" switch.
• Depress/release the clutch pedal. (MT model)
• Set the selector lever to P or N. (AT model)
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For details
concerning DTCs, refer to the List of DTC. <Ref. to
CC-24, List of DTC.>
CC-9