Subaru Impreza 2003 Service Manual page 3225

4. Front Door Panel
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the front door trim. <Ref. to EI-37, RE-
MOVAL, Front Door Trim.>
3) Remove the outer mirror assembly. <Ref. to
GW-17, REMOVAL, Outer Mirror Assembly.>
4) Remove the front door glass. <Ref. to GW-10,
REMOVAL, Front Door Glass.>
5) Remove the front door regulator and motor.
<Ref. to GW-14, REMOVAL, Front Regulator and
Motor Assembly.>
6) Remove the front door latch assembly. <Ref. to
SL-24, REMOVAL, Front Door Latch Assembly.>
7) Remove the front outer handle. <Ref. to SL-23,
REMOVAL, Front Outer Handle.>
8) Remove the front pillar lower trim to disconnect
the connector from body harness.
9) Put a wooden block on jack and place the jack
under front door panel. Support the front door with
the jack to protect it from damage.
10) Remove the checker bolts.
FRONT DOOR PANEL
11) Remove the door-side bolts for upper and low-
er hinges to remove the front door panel.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to the sliding area of door hinges.
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
<Ref. to EB-8, FRONT DOOR PANEL,
COMPONENT, General Description.>
EB-00012
EB-00013
EB-00014
EB-15
EXTERIOR BODY PANELS
EB-00015