Subaru Impreza 2003 Service Manual page 3237

2. Actuator
A: REMOVAL
CAUTION:
• Be careful not to apply excessive load to the
wire cable when adjusting and/or installing;
otherwise, the actuator may be deformed or
damaged.
• Do not bend the cable sharply with a radius
less than 100 mm (3.94 in); otherwise, cable
may bend permanently, resulting in poor per-
formance.
• When installing the cable, be careful not to
sharply bend or pinch the inner cable; other-
wise, the cable may break.
1) Disconnect the ground cable from battery.
2) Remove the clip bands from cruise control cable.
3) Loosen the nut which secures cruise control ca-
ble end to throttle cam, and then remove the cable
from throttle cam.
4) Remove the actuator attaching bolts.
5) Remove the actuator while disconnecting the
connector.
ACTUATOR
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Cable end nut:
NOTE:
(A): Must be adjusted when the cable end outer is
fixed in place, so that gap between throttle cam and
lever is 0 — 1 mm (0 — 0.04 in), otherwise, inner
cable deflection (D) is 1 — 8 mm (0.039 — 0.315 in)
when the throttle cable is installed.
(Must be attached while the throttle cam is being
pulled by wire cable.)
(B): Must be coated evenly on the cam end inner
connection.
(C): Cover must be inserted securely, until tip of ca-
ble touches cover stopper.
CC-00165
C: INSPECTION
Measure the cruise control actuator resistance.
CC-00166
If NG, replace the cruise control actuator.
CC-3
CRUISE CONTROL SYSTEM
12 N·m (1.2 kgf-m, 8.7 ft-lb)
(C)
(D)
3 2 1
6 5 4
Terminal No.
4 and 1
4 and 2
4 and 5
3 and 6
(B)
(A)
CC-00037
CC-00012
Standard value
Approx. 5 Ω
Approx. 5 Ω
Approx. 5 Ω
Approx. 39 Ω