Routing Cables Outside The Control Cabinet; Routing Converter Cables Inside And Outside A Control Cabinet - Siemens SINAMICS S210 Operating Instructions Manual

Routing converter cables inside and outside a control cabinet

Figure 3-1

Routing cables outside the control cabinet

● Maintain a minimum clearance of 25 cm between cables with a high level of interference
and cables with a low level of interference.
● Use shielded cables for the following connections:
– Converter motor cable
– Cable between the converter and braking resistor
– Signal and data cables
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA
Routing converter cables inside and outside a control cabinet
3.1 EMC-compliant installation of a machine or system
Configuring
37