Connection Systems - Siemens SINAMICS S210 Operating Instructions Manual

2.5

Connection systems

The motor is connected to the converter by a MOTION-CONNECT cable.
The cable is in one cable connection technology and called "OCC cable" in the following.
As a result of its flexibility and low diameter, it permits very tight bending radii.
The OCC cables are available in the following variants:
● MOTION-CONNECT 500
– Cost-effective solution for mainly fixed installation
– Suitable for low mechanical loading
● MOTION-CONNECT 800PLUS
– Meets requirements for use in cable carriers
– Suitable for high mechanical loading
– Oil-resistant
The OCC cables can be supplied in lengths by the decimeter.
Extensions and cabinet bushings are available for the OCC cables.
For additional information, see Chapter:
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA
- tested for horizontal movement distances up to 50 m
- not self-supporting
"Technical data and properties of the connection system (Page 204)"
Description
2.5 Connection systems
31