Password Reset - Siemens SINAMICS S210 Operating Instructions Manual

Commissioning and diagnostics in the Web server
6.2 First login
4. Confirm your password entry with "OK".
Remember the password or store the password in a safe place that cannot be accessed
by unauthorized persons.
5. The display changes to the Login screen form. Log in there with the administrator password.
Note
The display also changes to the Login screen form if you do not enter a password within 10
minutes.
If you wish to assign an administrator password for the first time, switch the converter off and
on again so that the initial input screen form appears again.

Password reset

It will be no longer possible to access the converter if the administrator password is lost. In this
case, you must reset the password. To do this, use a memory card that contains a configuration
with a known password.
Procedure:
Load a configuration for a converter which has a known administrator password and reset it
to factory settings.
1. Insert an empty memory card (max. 2 GB) into the PC.
2. Copy the configuration to the memory card (as a minimum, to the USER directory).
3. Insert the memory card card into the converter and switch on the converter.
4. Open the web browser and log on as administrator with the known password.
5. Reset the converter to the factory settings.
6. The converter starts with the factory settings. After the run-up, the input dialog for the
administrator password appears.
7. Re-assign the administrator password.
Remember the password or store the password in a safe place that cannot be accessed
by unauthorized persons.
8. Recommission the converter.
9. Save the changes.
110
Login/logout (Page 116)
Backup and restore (Page 153)
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA