Persons Authorized For Acceptance; When Do You Have To Conduct An Acceptance Test Of The Converter?; What Does The Acceptance Test For The Converter Consist Of? - Siemens SINAMICS S210 Operating Instructions Manual

Safety functions integrated in the drive
4.6 Acceptance - completion of commissioning

Persons authorized for acceptance

Personnel from the machine manufacturer, who, on account of their technical qualifications
and knowledge of the safety functions, are in a position to perform the acceptance test in the
correct manner are authorized to perform the acceptance testing of the converter.
Recommendations
With the acceptance test, you check whether the safety functions in the converter have been
set correctly.
● Perform the acceptance test with the maximum possible velocity and acceleration to test
the expected maximum braking distances and braking times.
● Alarm A01697:
This alarm is issued following each system startup and is not critical for acceptance.
After the acceptance test of the converter's safety functions, you must also check whether the
safety-related functions in the machine or system are functioning correctly.
Note
Examples of acceptance tests
The following acceptance tests are examples which demonstrate the basic procedure. They
are not suitable for every possible setting of the converter.
When do you have to conduct an acceptance test of the machine or plant?
You must conduct an acceptance test of the machine or plant in the following cases:
● After commissioning
● After a new firmware version has been uploaded to the converter
● When you change the parameter assignment of the converter

When do you have to conduct an acceptance test of the converter?

If you have replaced the converter, you have to conduct an acceptance test for it.
Note
When you replace the converter, an error message appears. Acknowledge this error message,
e.g. by switching off and on.

What does the acceptance test for the converter consist of?

Documentation
1. Supplement/change the hardware data
2. Supplement/change the software data (specify version)
76
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA