Bleed The Brake System - Taylor-Dunn RE-380-36 Operator's And Service Manual

BLEED THE BRAKE SYSTEM

NOTE: Start this procedure at the wheel furthest from the master cylinder,
6. Thoroughly clean the area around the master cylinder cap and remove the cap.
Maintenance, Service, and Repair
Do not ingest brake fluid or allow contact with skin or eyes. Always
wear protective clothing and a face shield when working with or
around brake fluid.
SKIN CONTACT
Flush area immediately with water for several minutes. If a rash or
skin irritation develops, get medical attention immediately.
EYE CONTACT
Immediately flush the eye with water for 15 minutes and call
physician.
INGESTION
Get medical attention immediately.
then work toward the wheel closest to the master cylinder.
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
36v - Located between the batteries (shown).
48v - Located on the right side panel
Brakes Page 9