Starting The Z500 And Displaying Images - Omron Z500 Operation Manual

SECTION 2
Basic Operations

2-1 Starting the Z500 and Displaying Images

This section describes how to start the Z500 and how to display images on the monitor.
Place the workpiece and adjust the Sensor position while monitoring the displayed image.
#1
Starting the Z500
1.
CHECK
2.
3.
The Image Monitor will be displayed.
CHECK
Z500
20
Operation Manual
Be sure that the basic Z500 components have been connected correctly.
Power Supply
Z500
Sensor
Before connecting components or wiring power supply lines and grounding wires, be sure
to refer to the relevant section in the Setup Manual.
REFERENCE
Refer to page 16 in the Setup Manual.
Turn ON the power supply to the monitor.
Turn ON the power supply to the Z500.
If the Image Monitor is not displayed, use the SHIFT + Right Keys or SHIFT + Left Keys
on the console to change the Monitors.
REFERENCE
Refer to page 29, Screen Types and Display Methods.
Console
ESC
× × × × × × × × × × × ×
× × × × × × × × × × ×
SHIFT
× × × × × × × × ×
× × × × × × × × × ×
Monitor
Scn 0
NEAR
OUT 0
+0005.18800
S+ /
TRIG ENT
CONSOLE
Run
9.96ms
FAR
BRIGHT
Sen0
[ 15]
LV
[ 170]
PEAK
Sen1
[ .]
LV
[ ]
DARK
PEAK
Zero's OFF
mm PASS
:Display S+ENT:Adjust