Advertisement
Quick Links
Download this manual
See also:
User Manual
Smart Laser Micrometer
ZX-GT
• High accuracy: 5-10 µm
• All surfaces
• Long sensing distance: < 500 mm
• Line width up to 28 mm
• Calculation unit for multiple heads
• Fast sampling time: 0.5 ms
• PC software for setup
Ordering Information
Sensors
Appearance
Separate type
Integrated type
Controller
Appearance
Accessories (Order Separately)
Set of Interface Unit and Setup software PCs
Output type
NPN
PNP
Interface Unit(RS-232C/Binary output)
Appearance
ZX-GT
Optical system
Measuring
width
Through-beam
28 mm
Power supply
Output type
DC
NPN
PNP
Model
ZX-GIF11A
ZX-GIF41A
Power supply
Output type
DC
NPN
PNP
Sensing
Resolution
distance
0 to 500 mm
10 µm
40 mm
Model
ZX-GTC11
ZX-GTC41
Model
ZX-GIF11
ZX-GIF41
Output type
Model
NPN
ZX-GT28S11
PNP
ZX-GT28S41
NPN
ZX-GT2840S11
PNP
ZX-GT2840S41
1
Advertisement
Related Manuals for Omron ZX-GT
Summary of Contents for Omron ZX-GT
-
Page 1: Ordering Information
40 mm ZX-GT2840S11 ZX-GT2840S41 Controller Appearance Power supply Output type Model ZX-GTC11 ZX-GTC41 Accessories (Order Separately) Set of Interface Unit and Setup software PCs Output type Model ZX-GIF11A ZX-GIF41A Interface Unit(RS-232C/Binary output) Appearance Power supply Output type Model ZX-GIF11 ZX-GIF41... -
Page 2: Specifications
(at binary level 70%) Linearity is given to be a typical error with respect to an ideal straight line when the distance between the emitter and receiver is 100 mm and light is blocked at a distance of 50 mm from the receiver. - Page 3 The error (ERR) state is displayed when all HIGH/PASS/LOW outputs turn OFF. Normally, wire the sync output wire directly to the emitter's sync input wire and run the Controller in the standard mode. On an NPN type Controller, use an NPN type emitter, and on a PNP type Controller, use a PNP type emitter.
-
Page 4: Interface Unit
Operating: 0 to +50°C Storage: -15 to +60°C (with no icing or condensation) Ambient humidity Operating and storage: 35 to 85% (with no condensation) Vibration resistance(durability) 10 to 150 Hz Single-amplitude: 0.35 mm for 80 min each in X, Y and Z directions Degree of protection IEC60529 IP20 Cable length RS-232C 0.5 m, binary output 2 m... - Page 5 Laser ON indicator (green) indicator (green) 54.1 Mounting hole dimensions 2-3.2 mm dia. holes Laser ON indicator (green) Optical axis Five, 6.5 mm dia. countersunk holes, depth 5 Laser alarm indicator(red) Optical axis setting indicator (green) 17.8 7.15 Optical Connector 54.1...
- Page 6 ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. In the interest of product improvement, specifications are subject to change without notice. Cat. No. Q20E-EN-01 Displacement sensors / Width-measuring Sensors...