#3
Confirm Trigger Settings
Check if measurements are being correctly performed with the set trigger contents.
Set the screen mode to Trig in advance.
CHECK
Refer to page 118.
1.
Press the SHIFT + Right Keys or SHIFT
+ Left Keys several times to switch to
Trend Monitor.
2.
Pass the workpiece under the Sensor.
The waveform is displayed from the trigger position set in
3.
Perform a workpiece measurement
several times to check that
measurement can be performed
correctly.
• When the measurement start and end positions have to be adjusted
Return to the procedure in
positions.
REFERENCE
#2
Scn 0
Run
Thru
OUT 0
+0005.18800
S+
/
:Display S+ENT:Adjust
#2
.
Scn 0
Run
Trig
Trigger-ON position
, with the waveform kept displayed, and adjust the
SECTION 4
Menus for Expert Menu
9.96ms
1div x: 1.000 [s]
y:+10.0000 [mm]
Zero's OFF
mm
PASS
9.96ms
1div x: 1.000 [s]
y:+10.0000 [mm]
Trigger-OFF position
Z500
Operation Manual
95