Profile Monitor - Omron Z500 Operation Manual

2-3-2 Profile Monitor

Use to check the status of the workpiece surface.
Surface condition of a workpiece can be monitored on a shaded 3-D image screen. Height information
and its chronological change can also be monitored.
Trend Display
By moving the workpiece, the profile graph (height information for 126 points) can be monitored in
chronological order for up to 10 seconds.
TRIG Key can be used for switching from waveform display to waveform display stop and vise versa.
The trigger function enables shaded 3-D image to be displayed at specified timing.
Display range and display time can be changed.
CHECK
Refer to page 121.
Shaded 3-D image display
Scn 0 Run
1div x: 1.000 [s]
y:+10.0000[mm]
Thru
+0005.18800
Sen 0
S+ / :Display S+ENT:Adjust
Movement orientation
REFERENCE
Profile Display
9.96ms
mm
PASS Measurement Result Display
Line beam
SECTION 2
Basic Operations
Z500
33
Operation Manual