Setting Measurement Conditions Using The Conversational Menus; Step 1 Starting Conversational Menus - Omron Z500 Operation Manual

SECTION 3
Menus for Conversational Menu

3-1 Setting Measurement Conditions Using the Conversational Menus

This section explains the procedures for using Conversational Menus, from setting measurement
conditions through to starting measurement.
The operating guides displayed on the screen can be used just like a conversation to help perform
procedures.
1
Starting Conversational Menus
Step
1.
2.
The mode selections will be displayed.
3.
The Z500 will enter Set Mode.
4.
Follow the instructions given by the operation guide displayed on the screen for the rest of the procedure.
Two Sensor
Z500
40
Operation Manual
The screen shown right will be displayed
when the Conversational Menus are
started for the first time.
Move the cursor to Run
ENT Key.
Use the Up and Down Keys to move the
cursor and select Set.
Select Next to start making the settings.
The selections for the sensors to be used for measurement will be displayed.
Select the Sensor number.
Scn 0
NEAR
and press the
OUT 0
+0005.18800
S+ /
Scn 0
STEP 1:Measurement method
STEP 2:Measurement region
STEP 3:Sensitivty adj method
Run
9.96ms
BRIGHT
Sen0
[ 15]
LV
[ 170]
PEAK
Sen1
[ .]
LV
[ ]
DARK
PEAK
Zero's OFF
mm PASS
:Display S+ENT:Adjust
Run
Set
Run
Tools
System
Save
Perform settings in
the following order.
Back
Next
FAR