Digital Monitor - Omron Z500 Operation Manual

2-3-3 Digital Monitor

Mostly used during line operation.
Two or more measurement results that have been set for the output numbers of the displayed scenes will
be displayed.
The measurement items can also be displayed instead of the judgment values.
CHECK
Refer to page 117.
Output number
Press the TRIG Key to switch the number.
Scn 0 Run
0 +0002.65432mm HI=+0010.00000
PASS LO=-0010.00000
1 +0004.65432mm HI=+0010.00000
PASS LO=-0010.00000
2 +0000.00000mm HI=+0010.00000
ERROR LO=-0010.00000
3 -----------mm HI=+0010.00000
LO=-0010.00000
S+ / :Display S+ENT:Adjust
TRIG TRIG
Scn 0 Run
4 +0002.65432mm HI=+0010.00000
PASS LO=-0010.00000
5 +0004.65432mm HI=+0010.00000
PASS LO=-0010.00000
6 +0000.00000mm HI=+0010.00000
ERROR LO=-0010.00000
7 -----------mm HI=+0010.00000
LO=-0010.00000
S+ / :Display S+ENT:Adjust
REFERENCE
Scn 0 Run
0 +0002.65432mm
Step: 2 pts
PASS
1 +0004.65432mm
Width
PASS
2 +0000.00000mm
Define
ERROR
3 -----------mm
S+ / :Display S+ENT:Adjust
9.96ms Judgment value
The judgment value for each
output number will be displayed.
HI: Judgment upper limit
LO: Judgment lower limit
Measurement value
Judgment result
---- will be displayed for output numbers
that have not been set.
9.96ms
9.96ms
Measurement items
SECTION 2
Basic Operations
Z500
35
Operation Manual