Omron Z500 Operation Manual page 77

The selection for measurement item will be displayed.
3.
Select the measurement item.
In this example, Select Edge position.
The setting screen for edge position will be displayed.
4.
Specify the level to be measured as the
edge.
Move the cursor with the Left and Right
Keys.
(Use these keys together with the SHIFT
Key to move the cursor quickly.)
The setting screen for edge position will be displayed.
5.
Specify the edge position regarded as
the measurement point.
Move the cursor with the Up and Down
Keys.
In some cases, the cursor will not be
CHECK
displayed on the intersection point of the
edge level and the edge position.
However, selection of an arbitrary cursor
will give the same measurement result
(the intersection point becomes the
measurement point), as long as the
selected cursor exists near the
intersection point.
A confirmation message will be displayed.
6.
Select Execute.
The setting will be registered and the screen in (2.) will return.
SECTION 4
Menus for Expert Menu
Measrmnt item
Height
Step: 2 pts
Step: 3 pts
Edge position
Width
Edge center
Peak/bottom
Define
Cursor
Measrmnt items will be set.
OK?
Execute Cancel Back
Operation Manual
Z500
75