Changing Scenes - Omron Z500 Operation Manual

5-4 Changing Scenes

The different situations (types of measurement workpiece and types of measurements required) in which
measurements are performed are called "scenes" and the measurement conditions set under Set Mode
are called "scene data." The Scene function can be used to set 16 types of measurement conditions.
If measurement conditions change, simply switch to change to a different measurement setup.
The methods used to switch, copy, and clear scenes are explained below.
5-4-1 Setting Measurement Conditions for Different Models (Changing Scenes)
Use the scene changing function to switch between different measurement
conditions for different measurement setups or measurement workpieces.
Scene 0 will be displayed by default when the power is turned ON, however, the
Z500 also accommodates scenes 1 to15.
The method for switching the scene on the Console is explained below.
The command for switching scenes can also be input from the terminal block or
via RS-232C.
For details on input from the terminal block, refer to page 154.
For details on input from RS-232C, refer to page 160.
1.
Move the cursor to Scn
ENT Key.
The Scene 0 to Scene 8 options will be displayed.
Use the Down Key to display the scene numbers 9 to 15.
2.
Move the cursor to the scene number to
be switched to and press the ENT Key.
The selected scene will be displayed.
REFERENCE
REFERENCE
and press the
SECTION 5
Other Functions
Scn 0 Run
Scn 0 Run
Scn 0
Scn 1
Scn 2
Scn 3
Scn 4
Scn 5
Scn 6
Scn 7
Scn 8
Operation Manual
Z500
125