Omron Z500 Operation Manual page 95

6.
Specify the trigger-ON position and
trigger level, and press the ENT Key.
Use the Left and Right Keys to specify
the trigger position.
Use the Up and Down Keys to specify
the trigger level.
Use these Keys together with the SHIFT
Key to move the cursor quickly.
When the trigger turns ON, the waveform above the trigger level is displayed at a position
CHECK
based on the position set here.
Trigger Position in the Center
The trigger-OFF setting screen will be displayed.
7.
Using the Left and Right Keys, specify
the trigger-OFF position.
Use the Left and Right Keys together
with the SHIFT Key to move the cursor
quickly.
The setting screen for measurement start timing will be
displayed.
8.
Using the Left and Right Keys, specify
the measurement starting position.
Use the Left and Right Keys together
with the SHIFT Key to move the cursor
quickly.
The time for cursor position (time after
CHECK
the trigger is turned ON) is displayed on
the lower part of the screen. Refer this
time for setting the measurement
starting position.
Trigger Position on the Left
The waveform before and Mainly the waveform after
after the trigger turns ON the trigger turns ON can be
can be monitored. monitored.
SECTION 4
Menus for Expert Menu
Trigger-ON position Trigger level
Trigger
1div x: 1.000 [s]
y:+10.0000 [mm]
Thru
Trigger-OFF position
Trigger
1div x: 1.000 [s]
y:+10.0000 [mm]
Thru
Measurement start position
Trigger
1div x: 1.000 [s]
y:+10.0000 [mm]
Thru
Measure start 249.00 ms
Time for cursor position
Operation Manual
Z500
93