Omron Z500 Operation Manual page 73

Types of Measurement Item (Continued)
Characteristic Quantity of Measurement Points
Selection
Measure the difference between the specified two edge
Width
positions.
Based on the specified two edge positions, measure the
Edge center
center.
Measure the peak or bottom point of the height within
Peak/bottom
the specified region.
Using the equation, set the measurement items.
The measurement result for an output number can be
Define
assigned to the equation.
REFERENCE
Selection
Define the average profile position within a specified region as the
Average
measurement point.
Define the peak profile position within a specified region as the
Peak
measurement point.
Define the bottom profile position within a specified region as the
Bottom
measurement point.
Set the back side of the workpiece for the measurement point.
Back This procedure is effective when glass sheets and other transparent
workpieces are measured.
Peak and Bottom
Peak Bottom
Region
Description
Refer to page 76.
*Height is set in OUT0 as the default setting.
Description
Back
SECTION 4
Menus for Expert Menu
Symbol
Surface
Back
Workpiece
Z500
Operation Manual
71