Omron Z500 Operation Manual page 60

SECTION 4
Menus for Expert Menu
Setting Measurement Region
CHECK
1.
The screen for specifying the region will be displayed.
2.
The cursor will be moved to the ending line.
3.
A confirmation message will be displayed.
4.
The setting will be registered and the screen in (1.) will return.
Z500
58
Operation Manual
Specify the region to be measured.
The Z500 adjusts sensitivity and performs measurements in a region that has
been previously set. Though the whole image can be used for the measurement
region, measurement accuracy can be raised by specifying a restricted
measurement region.
Correct measurement may not be possible at the boundaries of the measurement regions.
Leave space at the boundaries when setting the regions.
Select Image/Region.
Specify the starting line of the
measurement region.
Move the cursor with the Up and Down
Keys.
(Use these keys together with the SHIFT
Key to move the cursor quickly.)
Repeat the procedure described in (2.) to specify the ending line of the
measurement region.
Select Execute.
Scn 0 Set
Image Meas method
Compensatn Region
Meas set Sensitivity
Conditions Details
Output
Cursor
The measurement region
will be set. OK?
Cancel
Execute