Omron Z500 Operation Manual page 96

SECTION 4
Menus for Expert Menu
The cursor will be moved to the measurement ending position.
9.
CHECK
A confirmation message will be displayed.
10.
The setting will be registered and the screen in (2.) will return.
Z500
94
Operation Manual
Repeat the procedure described in (8.)
to specify the measurement ending
position.
The time for cursor position (time after
the trigger is turned ON) is displayed on
the lower part of the screen. Refer this
time for setting the measurement ending
position.
Select Execute.
Measurement end position
Trigger
1div x: 1.000 [s]
y:+10.0000 [mm]
Thru
Measure start 249.00 ms
Measure stop 2320.68 ms
Time for cursor position
The settings
will be changed.
OK?
Execute Cancel Back