5-3-4 Changing the Profile Monitor's Display Contents
Change the screen mode, the waveform display range, the waveform display
time, and cursor positions on profile and trend display.
Vertical setting
Maximum display value
Scn 0
Minimum display value
Mode
Thru
Refer to page 29 for details on the contents of display on the screen.
Note:
Profile cursor
Run
1div x:
1.000 [s]
y:+10.0000[mm]
Horizontal setting
(Display time)
REFERENCE
Item
Selection/Setting
Thru*
Mode
(See note.)
Trig
-9999.99999 to
Vert
9999.99999
Horiz
1.00 to 30.00s
(See note.)
(5.00s*)
Move cursr
The contents to be set are also used for the Trend Monitor. The contents that
have been finally set will become effective.
Trend cursor
Conversion values for X and Y axes
The units corresponding to 1 division (1 div)
on the waveform display are displayed.
If the setting is changed, the display
9.96ms
also changes.
Use these values as reference when
setting the values.
1div
x
The shaded 3-D image acquired through the
Sensor will be displayed continually.
A shaded 3-D image will be displayed in response
to the trigger timing.
(Updated when the trigger turns ON.)
Sets the maximum and minimum values displayed
on the screen.
The default setting varies depending on the Sensor
model connected.
Sets the display time (X axis) for the waveform
displayed on the screen.
Sets the profile and trend display positions.
The asterisk (*) indicates the default setting.
SECTION 5
Other Functions
y
1div x:
1.000
y:+10.000
Description
Z500
Operation Manual
121